THE LUNCH NOTEBOOK

DIY Silicone Food Dividers for Lunchboxes

Make your own silicone food dividers for lunchboxes. Learn which silicone to use, how to shape DIY lunchbox dividers, and how to fit reusable dividers.

3 min read9 viewsDIY Silicone Food Dividers for Lunchboxes
— · 0 votes
Contents
  1. Choosing the right silicone sheet
  2. Cutting DIY lunchbox dividers
  3. Holding dividers in place
  4. Questions about silicone lunchbox dividers
  5. How do you make lunchbox dividers at home?
  6. Can you use silicone for homemade lunch compartment inserts?
  7. What can I use instead of silicone for lunchbox dividers?
  8. How do you clean DIY silicone dividers?

DIY silicone food dividers are flexible inserts you cut or mold yourself from food-grade silicone to split a lunchbox into bento compartments. The job suits anyone who wants homemade lunch compartment inserts without buying a molded tray, and it needs only a silicone sheet or a simple mold, a cutting tool and a clean work surface. This page explains how to make lunchbox dividers, what silicone to choose and how to keep the dividers sitting where you put them.

Choosing the right silicone sheet

Food-grade silicone is the material that makes a divider safe to touch food, so check the label before you buy a sheet. Platinum-cured silicone holds its shape well and resists tearing when you cut narrow strips. A sheet thick enough to stand upright will separate meal components without folding over. Thin craft silicone can sag and is not sold for food contact.

Cutting DIY lunchbox dividers

Measure the inside of the lunchbox at the point where each divider will sit and add a small margin for a snug fit. Cut the silicone with sharp scissors or a craft knife on a cutting board, and cut straight lines so the divider stands without wobble. Round the corners so the silicone does not catch on the box edge. Test each piece dry before you pack food around it.

Holding dividers in place

A silicone divider stays put through friction when its cut edge presses lightly against the lunchbox wall. Press the strip into the box and check that the base touches the floor along its whole length. Very smooth boxes need a deeper cut or a small notch at each end to grip. Wash and dry the silicone before packing, since a wet surface lets the divider slide.

Questions about silicone lunchbox dividers

How do you make lunchbox dividers at home?

You make lunchbox dividers at home by cutting food-grade silicone sheet to the inner width of the box and pressing each strip into place. Measure the gap first, then cut with sharp scissors and round the corners. Test the fit while the box is empty so you can trim before food goes in.

Can you use silicone for homemade lunch compartment inserts?

Yes, food-grade silicone works well for homemade lunch compartment inserts because it flexes, wipes clean and can be cut to any shape. Silicone is heat resistant, so it sits safely beside warm food that has cooled a little. Pick a sheet sold for food contact, since craft silicone is not made for that use.

What can I use instead of silicone for lunchbox dividers?

Silicone has flexible alternatives for lunchbox dividers, including rigid plastic cut from a food-safe board and washed wooden strips. A small reusable cup or a paper muffin liner also works as a divider insert for loose items. Whatever you choose, make sure it is food-safe and fits the box without gaps.

How do you clean DIY silicone dividers?

Wash DIY silicone dividers in warm water with a little dish soap, then rinse and air dry them fully. Silicone can also go in a dishwasher if the sheet label says it is dishwasher safe. Dry the dividers before storing them so the surface stays free of residue.

Latest articles