How to Dice Onions
Learn how to dice an onion with a chef's knife, from peeling and trimming to horizontal and vertical cuts that give small, even onion cubes for any recipe.
Contents
- Tools you need for dicing an onion
- Trimming and peeling the onion
- Making the lengthwise cuts first
- Crosswise cuts that make the cubes
- Choosing the size of the dice
- Keeping your fingers safe while cutting
- Using diced onion in sandwiches and lunches
- Questions about dicing an onion
- How do you dice an onion properly?
- How do you dice an onion really small?
- Do you need to cut the root end off to dice an onion?
- Is a sharp knife needed to dice an onion?
- Should you peel an onion before dicing it?
To dice an onion, trim the top, peel it and halve it through the root. Then make lengthwise cuts and crosswise cuts with a sharp chef's knife, keeping the root intact. The root holds the layers together, which keeps the cubes even.
- Keep the root end intact until the last cut.
- Trim the top and peel the skin before you start.
- Use a sharp chef's knife and a stable cutting board.
- Make the lengthwise cuts first, then the crosswise cuts.
- Smaller cuts give a finer dice for sauces and soups.
Tools you need for dicing an onion
A chef's knife with a sharp blade is the main tool for dicing an onion. The blade should be long enough to pass across the whole onion in one stroke. A stable cutting board keeps the onion from sliding while you work. Wood, plastic, and composite boards all work, as long as they stay flat and dry.
Place a damp towel under the board so it does not move on the counter. A small bowl or tray holds the onion pieces as you cut them. Keep a second bowl for the peels and trimmed ends, so the board stays clear. Wipe the board dry between onions so the knife grips well.
A sharp knife cuts cleanly through the onion's cell walls. A dull blade crushes the flesh and releases more of the gas that stings your eyes. Sharpen the knife on a stone or steel before you start, if you have one. Keep a steel nearby to realign the edge during a longer session of cutting.
Trimming and peeling the onion
Start by cutting a thin slice off the top, the stem end, of the onion. Leave the root end attached, since it holds the layers together during cutting. Set the onion flat on the board, with the cut top facing up. Peel the skin from the top down, pulling off dry outer layers.
Cut the onion in half from the top to the root end, straight through the middle. Lay each half cut side down on the board so it rests flat. The flat side stops the onion from rolling when you make the cuts. Peel off any skin that remains on the cut halves before you slice.
Use the tip of the knife to remove any dry bits near the stem. Do not cut off the root end, which holds the onion together. Pull off any thin, papery skin that clings to the layers with your fingertips. Work over a bowl so the peel and trimmings stay out of your way.
Making the lengthwise cuts first
Lengthwise cuts run from the stem end to the root end, parallel to the board. Hold the onion half with a claw grip, fingertips curled under the knuckles. Make thin slices parallel to the board, stopping just short of the root end. Keep the blade straight and let the knife do the work.
The spacing of the slices sets the size of the finished dice. Closer slices give a finer dice, and wider slices give bigger pieces. Start with the cut closest to the root, then move toward the edge. Spread the slices evenly so the cubes come out the same size.
Do not slice all the way through the root, or the layers fall apart. Thick onions may need the slices made in two passes for control. Hold the knife steady and avoid sawing back and forth. Each slice should lie flat, so the next cut lines up with it.
Crosswise cuts that make the cubes
Crosswise cuts run across the lengthwise slices and form the cubes. Make them the same spacing as the lengthwise cuts for even pieces. Hold the onion steady with the claw grip, guiding the knife with your knuckles. Let the blade move down through the layers in a smooth, straight motion.
Cutting toward the root end keeps the pieces together until the last cut. Gather the diced onion with the side of the knife and move it to a bowl. Cut the remaining root end off once the rest of the onion is in pieces. Discard the root end or add it to a stock pot, if you keep stock.
Work through the onion gently, keeping the knife tip on the board. Lift the pieces with a bench scraper if they slide on the board. Clean the board and knife between onions to keep the dice neat. Store cut onion in a sealed container and keep it cold.
- Trim the top and peel the skin.
- Halve the onion through the root.
- Make lengthwise slices, leaving the root intact.
- Make crosswise cuts toward the root.
- Cut off the root end and discard it.
Choosing the size of the dice
The size of the dice depends on the dish, the knife, and your cutting pattern. A fine dice melts into sauces, while a larger dice holds its shape in stews. Use the same spacing for both directions so the pieces cook at the same rate. Uneven pieces cook unevenly, so take a little care with the first few cuts.
Fine dice suits sandwich spreads, dips, and sauces where onion should blend in. Medium dice works in soups, stews, and sautéed dishes, where pieces keep some bite. Coarse pieces suit grilling or roasting, where onion holds its shape on the heat. Adjust the spacing of the cuts to match the dish, not a fixed rule.
Wider spacing on the lengthwise and crosswise cuts gives larger cubes. Closer spacing gives smaller cubes that blend into a dish. Check a few pieces against the recipe before you cut the whole onion. Keep a note of the spacing that worked, so you can repeat it next time.
| Dice size | Cut spacing | Where it suits |
|---|---|---|
| Fine dice | Close lengthwise and crosswise cuts | Sandwich spreads, dips and sauces |
| Medium dice | Moderate spacing in both directions | Soups, stews and sautéed dishes |
| Coarse pieces | Wide spacing, larger cubes | Grilling and roasting |
Keeping your fingers safe while cutting
The claw grip keeps your fingertips tucked away from the blade. Curl your fingers under and let the knuckles guide the flat of the blade. Keep your thumb behind the fingers, never in front of the knife. Cutting with a claw grip reduces the risk of cuts, but it does not remove it.
Keep the knife tip on the board and rock the blade with a steady motion. Lift the blade straight up between cuts, rather than sliding it sideways. Dry the outside of the onion before you start, since a wet skin slides. Stop cutting when your hands feel tired and your cuts start to rush.
A deep cut needs prompt care from a doctor or a trained first aider. Keep a clean bandage and a first aid kit within reach of the counter. Do not reach across the board while the knife is still moving. Set the knife down on the board, not in the sink, when you pause.
Using diced onion in sandwiches and lunches
Diced onion adds sharp flavor to sandwiches, egg salad, and tuna mixes. Fine dice blends into the filling, so each bite gets a little onion. Rinse cut onion briefly in cold water to soften its bite, if the taste feels strong. Pat the pieces dry before packing, so the bread stays dry.
Store diced onion in a sealed container in the refrigerator until you pack it. Keep it apart from bread in a packed lunch, so the flavor does not spread. Use a cold pack to keep the lunch cool until lunchtime. Cut onions the day you eat them, if you want the sharpest taste.
Onion works in a warm dish, like a grilled cheese or a sandwich melt. Sauté the diced onion in a little oil until it softens and turns translucent. Cool the cooked onion before you add it to cold fillings for a packed lunch. Keep the onion pieces even, so each bite of the sandwich tastes balanced.
Questions about dicing an onion
How do you dice an onion properly?
Dicing an onion starts with trimming, peeling and halving it through the root. Then make lengthwise slices and crosswise cuts with a sharp knife, leaving the root end intact. The root holds the pieces together until the last cut, which keeps the dice even. Spacing the cuts evenly gives cubes of similar size from one onion.
How do you dice an onion really small?
Make the lengthwise and crosswise cuts closer together to dice an onion really small. Keep the root end intact and use a sharp chef's knife for clean, tight cuts. A fine dice melts into sauces and sandwich spreads, so the onion blends in. Work slowly at first, since small pieces need more control than large ones.
Do you need to cut the root end off to dice an onion?
No, the root end stays on while you cut and comes off at the end. Leaving it attached holds the layers together, so the onion does not fall apart. Once the slices and crosswise cuts are done, cut the root end off and discard it. Keep the root end for stock if you make your own stock at home.
Is a sharp knife needed to dice an onion?
Yes, a sharp knife is needed to dice an onion cleanly and with control. A dull blade crushes the onion, which releases more of the compounds that sting the eyes. Sharpen the blade before you start, and keep a steel nearby while cutting. A sharp blade also gives cleaner cuts and lowers the effort needed on each slice.
Should you peel an onion before dicing it?
Yes, peel the onion first, then trim it and cut it into halves for dicing. Pull off the dry outer layers and any thin skin that clings to the flesh. Peeling first keeps the skin out of the cubes and off the board. Work over a bowl, so the peel and trimmings do not scatter across the counter.